Frequently Asked Questions

You must obtain a permit from the Building Department before doing the following work:

• Replacing a Roof
• Installing New Siding
• Any Addition
• Interior Alterations
• Constructing a Deck
• Enclosing a Porch
• Installing a Dishwasher
• Most Electrical Work
• Finishing Your Basement
• Central Air Conditioning
• Installing a Swimming Pool (Above or Below Ground)
• New Furnace
• New Boiler
• New Hot Water Heater
• Fence
• Fireplace 
• Sheds
• Underground Sprinkler System
• Driveways and Sidewalks

This is a partial list, when in doubt, call the Building Department at 201-641-4950, opt. 4.

Carpenters do not have to be licensed in New Jersey; however, Plumbers, Electricians, and Fire Alarm contractors are required to have a State License.

Homeowners of an owner-occupied single-family home may do their own work. They may not have a friend, relative, or neighbor do the plumbing or electrical work; the homeowner must personally do the work.

Note: A Permit is Still Required From the Building Department.

Any other structure, including owner-occupied two-family homes, requires that all plumbing and electrical work be performed by NJ-licensed contractors.

For ordinary repairs and maintenance work, including exterior and interior painting (the C-1 Business Zone requires a review from the Historic Preservation Commission for exterior painting). Wallpapering, installation, or repair of any interior finish of less than 25% of the wall area in any room. (Paneling shall not be considered an ordinary repair and requires a permit.)

The installation of any door, window, or garage door in the same opening without altering the dimensions of the framing of the original opening. The repair of any non-structural member, such as a partial railing or kitchen cabinet. The replacement or repair of any interior or exterior trim or molding.

The installation of any flooring material. In a commercial building, carpeting requires a permit. The repair of existing roofing material with a like material, not exceeding 25% of the total roof area within a 12-month period.

Replacing a faucet, as long as the plumbing does not have to be rearranged.

Note: Check With the Building Department Before You Start, to Make Sure.

Ask your contractor for a reference list and check with those on the list. Most legitimate contractors do not go door to door seeking work. Check our list for when permits are required. If your contractor states that he does not need a permit and it is on the list, do not fall for his line; the penalty for working without the required permits can be as much as $500 per day.

The Building Department may not recommend contractors; however, we can give you 3 names of contractors that we have not had any problems with. But we still do not recommend them.

N.J. State Law 13:45A-16.2 States: Final Inspections are Required Before Final Payment is Made to the Contractor.

Either the homeowner or the contractor can take out a building permit; however, this office recommends that you have the contractor take care of this responsibility. Plumbing and Electrical permits, when the work is being done by a contractor, must be taken out by the contractor. Remember, only the owner-occupant of a single-family home may do their own plumbing and electrical work.

Remember, the purpose of construction permits is for the health, safety, and welfare of the building occupants and the public.

Permit requirements are State Law and strictly enforced by the Village Building Department.

You can also help the Village and your neighbors by maintaining your property in a way that you and your neighbors can be proud of.

The older your home is, the more likely you are to find lead paint. The only way to know for sure is to have it tested. Testing can be done by an environmental or home inspection firm that has a New Jersey Department of Community Affairs lead evaluation certification. Lead was banned from house paints in 1978…so any house built before then could have lead paint in it.

If the lead paint is in good condition, you can probably just paint or wallpaper over it. But if it’s peeling or chipping, it is a health hazard and should be either safely removed or covered. One of the safest methods of dealing with lead paint is to cover it with a material such as paneling or wallboard.

You may be able to do small jobs yourself, but projects that produce lead dust and paint chips should be left to a contractor who has a New Jersey Department of Community Affairs lead abatement certification.

Note: Removing lead paint can be hazardous to you and your family if not done safely.

There are three common methods:

1. Replacement means removing leaded doors, windows, and woodwork and installing new lead-free replacements. This method usually creates the least amount of lead dust.
2. Enclosure or Encapsulation means covering surfaces with a non-leaded material. Rigid materials, such as paneling or wallboard, provide the most durable protection, especially on deteriorating surfaces. On intact surfaces, some paint-on coatings or wallpapers may provide adequate protection. Unless a lot of surface preparation is necessary, these methods are also usually a safe way of dealing with lead paint.
3. Paint removal can be done either in the home or off-site (windows, doors, and woodwork can be removed and sent out to be shipped).
   • Off-site paint removal is a fairly safe method, although some dust and debris are produced when components are removed.
   • Most methods of on-site paint removal create dangerous levels of lead dust and debris. This type of work requires an approved respirator and protective clothing.
   • Never dry sand lead paint because very high levels of dust are produced. If sanding is necessary, wet sanding is safer.
   • Be careful if you plan to use chemical paint removers! Some are flammable and contain toxic solvents. Others can cause skin or eye irritations if not used properly. Follow directions carefully!
   • The use of heat to remove lead paint can produce toxic fumes and may be a fire hazard. Using a heat gun is safer than open flame burning.
   • If you decide to scrape lead paint, be sure you catch all paint chips on plastic sheets. Wet scraping is safer because it produces less dust than dry scraping.

Note: The safest removal methods are those that create as little dust and debris as possible.

• Plan to delead one room at a time and seal off the work area from the rest of the house with plastic sheets and duct tape.
• Remove furniture, carpeting, appliances, bedding, and toys from the work area. Cover floors with 2 layers of heavy plastic to catch all particles and debris. Also, cover heating and air conditioning ducts with plastic. For outdoor projects, use plastic to catch all debris and to cover shrubs and other vegetation.
• Do not let children, pregnant women, or pets stay in the house while lead paint is being removed. They may return only after a safe cleanup has been completed.
• Wear coveralls (or separate work clothes), shoe covers (for separate work shoes), gloves, a hat, and eye protection.
• Keep street clothes in a clean area, separate from clothes worn during lead paint removal. All work clothes should be removed before eating and after cleaning up the work area. They should also be washed separately.
• Eat and drink away from the lead removal area. Food and drinks should never be stored in the work area. Do not smoke or chew gum, or use tobacco while working.
• Wash your hands, arms, and face with soap and warm water before eating. Also, rinse your mouth thoroughly.
• Wear a properly functioning respirator, approved by NIOSH, the National Institute for Occupational Safety and Health. It should be equipped with a high-efficiency filter cartridge, color-coded purple for toxic dusts. Wash the face piece at the end of each day and store it in a clean area.
• This work may require a building permit. Check with your local building officer.

Note: Paper masks do not protect you from lead dust.